12
Waco Instruction Manual
REVERSE SWITCHES
Reversing switches are used to reverse the
direction of the four fl ying controls. They are
factory-set and should NOT be switched for
fl ying your Waco.
The reversing switches are located on the front
panel of the transmitter. The correct position
of the switches is shown.
PAIRING THE ESC AND TRANSMITTER
42. PLEASE NOTE: The fi rst time that the model
is powered up the ESC must recognize the
transmitter and verify the range of throttle
motion. Follow these easy steps.
43. With the throttle stick at its lowest position,
turn on the transmitter and then plug the fl ight
battery into the ESC.
Note: Photo shows a mode II transmittter
44. After a few seconds there will be a beep
tone, move the throttle stick to full throttle,
there will be another beep tone but the motor
will not start.
45. Return the stick to its lowest position for
the fi nal confi rmation tones after which the
throttle will work normally.
46. Please note that this process only needs to
be done one time. After this the throttle will
operate normally for all subsequent fl ights.
SERVO REVERSER
1
2
3
4
Channel No. references:
1 - Aileron
2 - Elevator
3 - Throttle
4 - Rudder
