11
12
7
4
23
4
15
31
2
Detail G
Figure 3
Figure 3
Figure 7A
First Table Top
13.
On one side of the table attach slotted end of safety strap #6 to
INSIDE
of Leg #2 using one bolt #39, one spacer #30, one washer
#24, and one hex nut #15. Tighten hardware until snug but do not
overtighten. Tubes must pivot freely. See
Detail H
.
14.
Attach other end of safety strap #6 to
OUTSIDE
of linkage #4
using one bolt #9, one washer #24, one spacer #30, and
one hex nut #15 as shown in
Detail H.
12.
Attach end of linkages #4 with two holes to
INSIDE
of Leg #2 as shown
in
Detail G & Detail H
. Secure through end hole with screws #23,
locknuts #15 and plastic spacers #31. Tighten hardware snug enough to
keep table stable but do not overtighten. Tubes must pivot freely.
Important! Do NOT put other safety strap #6 on this
table half. It will be installed on second table half later.
15.
Gently tap caster sockets #12 into U-support #7 until
flange on sockets touches the edge of the tube.
DO
NOT HIT CASTER SOCKET DIRECTLY WITH A
HAMMER! SET A PIECE OF WOOD ON CASTER
SOCKET AND HIT PIECE OF WOOD TO DRIVE
CASTER SOCKET INTO U-SUPPORT.
16.
Insert casters #11 into caster sockets #12.
See
Figure 7A
.
8
15
24
30
30
6
31
39
23
2
4
9
24
15
Detail H
15
1/4” Locknut
(
Qty. 3
)
39
1/4-20 x 2 1/2 Hex Head Bolt
(
Qty. 1
)
1/4-20 x3 1/4 Hex Head Bolt
(
Qty. 2
)
30
3/4” Spacer
(Qty. 2
)
31
5/16” Spacer
(
Qty. 2
)
24
Plastic Washer
(
Qty. 2
)
1/4-20 x 1 1/2 Bolt
(
Qty. 1
)
9
