22
8
DO
NOT DUNK ON THIS UNI
T
.
DO
NOT HANG FROM ANY PART OF
THIS
UNIT , INCLUDING THE BACKBO
ARD, RIM,
SUPPORT BRACES OR NET
.
4L
-8
15
2-0
1
W
ARNING
!
Actuator Tab
6.
5.
NOTE: If necessary, use a rubber mallet
to tap in Pivot Tube (#14)
While still on the two padded saw horses, Slide tab on Actuator (#16) between Post
Ears (#30) and secure using one bolt (#19), two washers (#20) and one lock nut
(#21). Tighten Lock Nut (#21) snug but
do not over tighten
. See
Figure 6
.
At this time
also tighten nuts
(#4) from
Step 4
.
7.
Secure two stop spacers (#10) to pole, as shown in
Figure 6
, using one hex
bolt (#22) and one lock nut (#4). Tighten Lock Nut (#4) but
do not over
tighten
.
If not already pre-assembled, slide Plastic Actuator Sleeve (#15) over Steel Actuator (#16)
and place Actuator Cap (#13) on top. Align holes in all 3 parts and slide Pivot Tube (#14)
through holes in Actuator Cap (#13), Plastic Actuator Sleeve (#15) and Steel Actuator Tube
(#16) until equal amounts stick out through both sides of actuator. See
Figure 6.
Figure 6
NOTE: Make sure (#14) Pivot Tube is
installed through all three parts:
1. Actuator Cap (#13)
2. Plastic Sleeve (#15)
3. Steel Actuator T
ube (#16)
3
4
20
21
20
19
30
(#22) Bolt goes
in upper hole
