9
8.
Note: make sure lettering is right side up. (See Side View).
DO NOT tighten bolt (#22) at this time. (See Figure 7.)
9.
IMPORTANT! Nylon washers (#5) adequately space
painted parts at all pivot points. Neglecting the use of
these washers will result in rusted parts.
NOTE: All board arms are made of rectangular tubing.
Tightening hardware too tight may damage tubing
and make adjustment of system difficult.
Figure 8
DO N
OT D
UNK
ON THIS UN
IT
.
DO
NO
T HA
NG
F
RO
M
A
NY
P
AR
T O
F T
HI
S
UN
IT , INC
LU
DIN
G TH
E B
ACK
BOAR
D, R
IM
,
SU
PPO
RT
B
RA
CES
O
R N
ET
.
4L
-8152-
01
W
ARNI
NG
!
DO
NOT DU
NK
ON THIS UN
IT .
DO NOT
HA
NG
FROM ANY PART
OF T
HIS
UNIT
, INCLUDING T
HE BACK
BOARD, RI
M
,
SUPPORT
BRA
CES
OR NET
.
4L-
8152-01
W
ARNING
!
SIDE VIEW
DO NOT
DUNK O
N THIS U
NIT .
DO NOT
HANG F
ROM AN
Y PART
OF THIS
UNIT , IN
CLUDIN
G THE B
ACKBO
ARD, RIM
,
SUPPO
RT BRA
CES OR
NET.
4L-8152
-01
WARN
ING
!
Note: Small amounts of clear tape can be used to adhere
Plastic Washers (#5) to Pole. This will make assembly easier.
Figure 7
Attach lower arms (#11) to Top Pole (#3), as shown in
Figure 7
, using a hex bolt (#22), two flat washers (#18),
two plastic washers (#5) and lock nut (#4).
Secure Actuator (#16) to Lower Arms (#11) using one
bolt (#22), two flat washers (#18), two plastic washers
(#5) and one lock nut (#4). See
Figure 8.
Tighten
both bolts (#22)
snug but, do not over tighten.
Board Arms must pivot freely.
