7
4
Detail G
Figure 5A
First Table Top
12.
Attach slotted end of safety strap #6 to
INSIDE
of Leg #2
using one bolt #29, one spacer #30, one washer #24, and
one hex nut #15. Tighten hardware until snug but do not
overtighten. Tubes must pivot freely. See
Detail H2
.
Important! Do NOT put other
safety strap #6 on this table
half. It will be installed on
second table half later.
23
4
15
31
2
4
15
1/4” Locknut
(
Qty. 3
)
29
1/4-20 x 1 ¾” Hex Head Bolt
(
Qty. 1
)
1/4-20 x 2 ¾” Hex Head Bolt
(
Qty. 2
)
30
3/4” Spacer
(Qty. 2
)
31
5/16” Spacer
(
Qty. 2
)
HARDWARE NEEDED
24
Plastic Washer
(
Qty. 2
)
1/4-20 x 1 1/2 Bolt
(
Qty. 1
)
9
HARDWARE NEEDED
15
23
29
30
24
15
4
(Longer)
(Longer)
31
Detail H2
30
6
9
24
4
Detail H1
15
10.
Attach safety strap #6 to linkage #4. Be sure to attach on the end of
linkage with
TWO
holes. Use one bolt #9, one washer #24, one
Spacer #30, and one hex nut #15. See
Detail H1.
Note
: This is the end of the
table with no rails.
11.
Attach end of linkage #4 with the attached Safety Strap #6
INSIDE
of
U-Leg #2 as shown in
Detail H2
. Secure through end hole with bolt
#23, Spacer #31 and locknut #15. Tighten hardware snug enough to
keep table stable but do not overtighten. Tubes must pivot freely.
2
2
13.
Attach linkage #4
INSIDE
other end of U-Leg #2 as
shown in
Detail G
. Secure through end hole with bolt
#23, plastic spacers #31 and locknuts #15. Tighten
hardware snug enough to keep table stable but do not
overtighten. Tubes must pivot freely.
6
8