ESCALADE Mizerak P0900, Assembly Instruction Manual

Page: 8 / 24

8
Threaded studs on P4 Rail
must be facing toward the
back as shown.
SIDE VIEW
OF TABLE
3
Figure
BEAM
SUPPORTS
THE FRONT OF
DRAWER WILL
GO ON THIS SIDE
BOTTOM VIEW
OF TABLE
THE FRONT OF
DRAWER WILL
GO ON THIS SIDE
DETAIL A
Threaded studs on P4 Rail must
be facing toward the back.
Threaded studs on P4 Rail
must be facing toward the
back as shown.
Threaded studs on P4 Rail must
be facing toward the back.
P4
7. Attach Mounting Rails P4 , to the support Beams with four H1 screws. Attach
screws H1 through the mounting slots and into the pre-drilled holes you made,
check to make sure Mounting Rails square, straight and centered on beams
before tightening,
DO NOT over-tighten screws. The threaded studs should
be facing toward the back. See Figure 3 , Detail A & Side View .
BEAM
SUPPORTS
CAUTION:
DO NOT OVER TIGHTEN SCREWS! BECAUSE YOU COULD STRIP SCREWS
IN THE WOOD BEAMS DOING IRREPARABLE DAMAGE TO THE TABLE.
H1
H1