6
BOTTOM VIEW
OF TABLE
OF SIDE APRON
BEAM
SUPPORTS
16”
1.
Determine which side of your pool table you want to attach your Accessory Drawer
and how far in (recessed) from the
bottom edge
of Side Apron.
1
Figure
2.
Measure 4” from the outside of the front face of the Drawer to the center of the
Beams on your table. Mark the location of where you will drill the pilot holes,
making sure hole marks are parallel to each other. See
Figure 1
.
3.
Measure 20” from the outside of the Front of the Drawer (or 16” from the first set
of holes) to the center of the Beams. Mark the location of where you will drill the
pilot holes, making sure hole marks are parallel to each other. See
Figure 1
.
4.
Double check the makings for the pilot holes before drilling. Hole markings must
be centered and square to other hole markings for proper drawer alignment.
Using a
7/64” bit
, drill pilot holes about 1” deep into the Beam supports,
keep
Drill straight when drilling so pilot hole is as straight as possible.
BOTTOM EDGE
FRONT OF
DRAWER
4”
20”
location of the first
row of mounting holes
location of the Second
row of mounting holes
BEAM
SUPPORT
SIDE VIEW
OF TABLE
OF SIDE APRON
FRONT OF
DRAWER
DETERMINE IF YOU WANT YOUR
DRAWER TO BE
FLUSH
TO
THE SIDE APRON OR
RECESSED
.
NOTE
:
4”
20”
BOTTOM EDGE
