23
8
Figure
PARTS NEEDED:
1 - (P1) Drawer Assembly
2 - (H2) Hex Nuts
11.
Attach Drawer Assembly by the threaded studs to both
end hanger
assemblies
with two
H2
Hex Nuts.
See
Figure 8
.
THE FRONT OF DRAWER
WILL GO ON THIS SIDE
OF THE TABLE
Hanger
Assembly
H2
NOTE:
Hanger Assembly
can extend
DETAIL D
Congratulations your assembly is complete!
Height
Adjustment
nut
12.
Adjust height of your drawer to the desired height with the four Hanger
assemblies, making sure that drawer is level and that there is enough clearance
to open and close drawer. Once drawer is at the desired height tighten the
height adjustment nuts on the Slider Assemblies to hold drawer at that height.
Do a final check of all fasteners to ensure all are tight.
See Detail D
.
