9
HANDLE BACKBOARD WITH CARE, IT IS A GLASS
PRODUCT. ALWAYS WEAR SAFETY GLASSES AND
GLOVES WHEN HANDLING GLASS.
ATTACHING BACKBOARD TO BOARD ARMS REQUIRES
AT LEAST FIVE CAPABLE ADULTS.
Figure 11
16.
With at least four capable people, raise
the backboard assembly up and have
the fifth person attach Lower Board Arms
to the Rim Support (# 21) on backboard
using one bolt (#8), two washers (#3),
two Plastic washers (#5) and one
Locknut (#4). See Figure 11.
22
23
Figure 10
21
Detail B
Detail A
14.
of bracket on each side of the Backboard (#23) as
shown in Detail A.
15.
Insert two Board Bushings (#33) in to the rim support
(#21). See Detail B.
Insert a Two Way Step Bushing (#22) in to the inside
This is a pivot point. Snug is tight enough.
Note: DO NOT over tighten these bolts.
Note: If the Step Bushing (#22) and Board Bushing (#33)
are not already pre-installed follow step 14 and 15.
17.
Attach Upper Board Arms to upper mounting tubes on
backboard using two bolts (#20), four washers (#3)
four Plastic Washers (#5) and two Locknuts (#4).
This is a pivot point. Snug is tight enough.
Note: DO NOT over tighten these bolts.
See Figure 11.
