8
Note: Tighten bolts snug but, do not over tighten. Board
Arms must pivot freely.
6.
7.
If the two Tube Plugs (#9) are not already installed insert them into open
ends of Upper Arms (#6L and 6R). It may be necessary to use a rubber
mallet to tap plug in.
Attach Upper Arms (#6L & 6R) to pole (#2), as shown in F igure 7. Using a bolt (#8), two Flat
Washers (#3), four plastic washers (#5) and hex nut (#49).
Figure 7
6R
6L
Drain Holes must be
on bottom Side
8
49
Drain Holes must be
on bottom Side
Summary of Contents for GOALRILLA B5000
Page 2: ...2 ...
