SECTION 2
INSTALLATION
14
PILOT ARC CABLE - 37339 (50’)
37340 (100’)
POWER CABLE - 37341 (50’)
37342 (100’)
ARC STARTER
37338
WORK
CABLE(25’)
(Supplied with
PCM-875)
AIR HOSE - 37343 (50’)
37344 (100’)
ARC STARTER CABLE - 37410 (50’)
37411 (100’)
PT-20AM - 21785 (4.5’)
21786 (17’)
SCHEMATIC - MECHANICAL SYSTEM SETUP (See Figure 2-4 for detailed connections)
Figure 2.3 - MECHANICAL CUTTING INTERFACE DIAGRAM
CNC Interface Connection (Located inside console, left side of base.)
2.8 MECHANIZED CUTTING INSTALLATION WITH THE PT-20AM TORCH
NOTE:
Use Cable P/N 2239902
(UL / CSA approved cable
Flex, 20 guage, 12 conductor
with copper braided shield)
Installation for mechanized cutting should be performed by an experienced service technician. Do NOT permit
untrained persons to install, operate, or maintain this equipment. Be sure to read all Safety Precautions
before installing or servicing this equipment.
Summary of Contents for PCM-875
