ESAB Origo M13 Feed 304, Instruction Manual

Page: 12 / 32

© ESAB AB 2002
- 12 -
bm34d1ea
5.6 Changing / loading wire Feed 304
S
Open the side panel.
S
Disconnect the pressure sensor by folding it backwards, the pressure rollers
slide up.
S
Straighten out the new wire 10-20 cm. File away burrs and sharp edges from the
end of the wire before inserting it into the wire feed unit.
S
Make sure that the wire goes properly into the feed roller's track and into the
outlet nozzle or wire guide.
S
Secure the pressure sensor.
S
Close the side panel.
5.7 Changing / loading wire Feed 484
S
Open the side panel.
S
Press down and pull the pressure device towards you and up.
S
Pull out the bogie.
S
Straighten out the new wire 10-20 cm. File away burrs and sharp edges from the
end of the wire before inserting it into the wire feed unit.
S
Make sure that the wire goes properly into the feed roller's track and into the
outlet nozzle or wire guide.
S
Reinstall the bogie.
S
Close the side panel.
5.8 Changing feed rollers on Feed 304
S
Open the side panel.
S
Disconnect the pressure sensor (1) by folding it
backwards
.
S
Disconnect the pressure rollers (2) by turning the
axle (3) 1/4 turn clockwise and pulling out the axle.
The pressure rollers disconnect.
S
Disconnect the feed rollers (4) by unscrewing the nuts
(5) and pulling out the rollers.
During installation, repeat the above in the reverse order.
Choice of tracks in the feed rollers
Turn the feed roller with the dimensioning mark for the required
track towards you.
GB