ESAB Fabricator 181i, Service Manual

Page: 10 / 84

ESAB FABRICATOR 181i
INTRODUCTION 2-2 Manual 0-5449
2.05 Transportation Methods
!
WARNING
Disconnect input power conductors from de-energized supply line before moving the welding
Power Source.
Lift Power Source with handle on top of case. Use handcart or similar device of adequate capacity. If using a fork
lift vehicle, secure the Power Source on a proper skid before transporting.
2.06 User Responsibility
This equipment will perform as per the information contained herein when installed, operated, maintained and
repaired in accordance with the instructions provided. This equipment must be checked periodically. Defective
equipment (including welding leads) should not be used. Parts that are broken, missing, plainly worn, distorted
or contaminated, should be replaced immediately. Should such repairs or replacements become necessary, it is
recommended that such repairs be carried out by appropriately qualified persons approved by ESAB. Advice in
this regard can be obtained by contacting an Accredited ESAB Distributor.
This equipment or any of its parts should not be altered from standard specification without prior written approval
of ESAB. The user of this equipment shall have the sole responsibility for any malfunction which results from
improper use or unauthorized modification from standard specification, faulty maintenance, damage or improper
repair by anyone other than appropriately qualified persons approved by ESAB.
2.07 Fabricator 181i Portable System Package (Part No. W1003181)
A-12920