ESAB Buddy Arc 180, Instruction Manual

Page: 7 / 20

© ESAB AB2011
- 7 -
bh40d1e
Duty cycle
The duty cycle refers to the time as a percentage of a ten-minute period that you can weld or cut at
a certain load without overloading. The duty cycle is valid for 40
°
C.
Enclosure class
The IP code indicates the enclosure class, i. e. the degree of protection against penetration by solid
objects or water. Equipment marked IP23 is designed for indoor and outdoor use.
Application class
The symbol indicates that the power source is designed for use in areas with increased
electrical hazard.
4 INSTALLATION
The installation must be carried out by a professional.
4.1 Location
Position the power source such that its cooling air inlets and outlets are not
obstructed.
4.2 Mains power supply
Make sure that the welding power source is connected to the
correct supply voltage and that it is protected by the correct
fuse rating. The outlet shall have a protective earth
connection.
Rating plate with supply connection data
4.2.1 Recommended fuse sizes and minimum cable area
Arc 180 Arc 200
Mains voltage 230V 1
∼ $
10%, 50/60 Hz
Mains cable area mm
2
3 G 2.5 3 G 2.5
Phase current I
1eff
(TIG) 14.7 A 16.6 A
Phase current I
1eff
(MMA) 19.7 A 24.1 A
NOTE!
Use the power source in accordance with the relevant national regulations.
GB
ARC WELDING SUPPLIES - 07 847 7870