Erreka KAIROS MSB-027/01, Quick Installation Manual

Page: 20 / 24

8
¡ ATTENTION ! The 24Vdc flash light output is not fixed output but flashing. To connect a fixed or a fixed mode flash
light for the proper function.
NOTE (Parameter F9)
Exterior Photocell: Only be activated in case of door closing.
Interior Photocell: Can be activated in door opening and door closing..
Function Settings
Encoder/ Limit switch
Dual or Single Gate
Over Current Setting
Operation Speed
Deceleration function
Deceleration Speed
Open/ Close delay of dual
gate operation adjustment
Auto-Close adjustment
Photocell function mode
(Open-close,
interior-exterior)
Pedestrian Mode function
Pre-Flashing function
F1
F2
F3
F4
F5
F6
F7
F8
F9
FA
FB
F1-1
F1-2
F1-3
F2-1
F2-2
F3-1
F3-2
F3-3
F3-4
F4-1
F4-2
F5-1
F5-2
F6-1
F6-2
F7-1
F7-2
F7-3
F7-4
F7-5
F7-6
F7-7
F7-8
F7-9
F8-0
F8-1
F8-2
F8-3
F8-4
F8-5
F8-6
F8-7
F8-8
F9-1
F9-2
F9-3
F9-4
FA-0
FA-1
FB-0
FB-1
Motor only
Motor with limit switch
Motor with encoder
Dual Gate
Single Gate
2A
3A
4A
5A
100% Full Speed
80% Full Speed
Function ON
Function OFF
70% Full Speed
50% Full Speed
2 sec.
3 sec.
4 sec.
5 sec.
6 sec.
7 sec.
8 sec.
9 sec.
10 sec.
OFF
3 sec.
10 sec.
20 sec.
40 sec.
60 sec.
120 sec.
180 sec.
300 sec.
Mode 1
Mode 2
Mode 3
Mode 4
OFF
ON
OFF
On
1. The factory setting is "F1-1".
1. The factory setting is "F2-1".
1. The factory setting is "F3-1".
2. Please make sure that the parameter F3 is always in F3-1
in case of system learning process.
1. The factory setting is "F4-1".
1. The factory setting is "F5-1".
1. The factory setting is "F6-2".
1. The factory setting is "F7-1".
1. The factory setting is "F8-2".
1. The factory setting is "F9-4".
Mode 1: Photocell Exterior FT1- Photocell Open FT2
Mode 2: Photocell Exterior FT1- Safety Belt FT2
Mode3: Photocell Exterior FT1- Open Device FT2
Mode 4: Photocell Exterior FT1- Fotocélula Interior FT2
1. When function on and push B key in the transmitter, one
gate will open partically.
2. The factory setting is "FA-1".
1. When function ON, the light will flash before the gate
operate 3 seconds. If set OFF, the flash light will operate
with motor in the same time.
2. The factory setting is "FB-0".
LED Display Definition Parameter Mode Description