Indicators
ELECTRA-T24 The indicator working status is shown as the following table
Indicators
Title
Color
Work
status
Description
POWER
Power
indicator
Red
Solid
Power is normal
Off
No power, the power switch is not
turned on, power supply is
abnormal
POE
POE
power
indicator
Red
Solid
The corresponding RJ45 port is
connected to the powered device
and the power supply is normal
Off
The corresponding RJ45 port is not
connected to the powered device or
the power supply is abnormal
LINK/ACT Connection
indicator
Green
Blinking
A valid link is established
Off
An invalid link is established
SYS
System
indicator
Green
Blinking
System is functioning properly
Off
System is functioning improperly
Software is damaged
G1-4
SFP
indicator
Green
Blinking
A valid link is established on the
SFP port
Off
An invalid link is established on the
SFP port
Shortcut button
QOS
: Improve video data processing capabilities and improve the
monitoring of Caton and Mosaic phenomena in the network
CCTV
: 1-8 port rate down to 10Mbps, but the transmission distance up to
250 meters
VLAN
: Isolating ports 1-24 from each other, suppress network storms
effectively and improve network performance
AI power supply
: Detect PD, power failure and restart dead equipment
RJ45 Port
ELECTRA-T24 with24 10/100/1000Mbps PoE port
，
all ports support IEEE802.3af
and IEEE802.3at standard
When the switch mode of operation is CCTV mode, 1-8 port can support 250 meters
power supply with 10Mbps speed rate
SFP Port
ELECTRA-T24 provide four Gigabit SFP optical ports (G1~G4), can be inserted into
the Gigabit SFP module
RST Button
When the switch is powered on, press the button with the needle to release the
device and enter the restarting state. When the SYS lamp restarts, the device
restarts. When the switch is powered on, press and hold the button for more than 5s
to release the button and enter the reset state. When SYS is re-lit, the device is
reset successfully
Console port
