Erie water treatment IQsoft, Technical Manual

Page: 9 / 28

ELECTRONIC CONTROL PANEL
Page 9
PROGRAMMING INSTRUCTIONS -
CONFIGURATION PARAMETERS

All configuration parameters on this appliance have
been pre-programmed in the factory, to offer optimal
performance in a wide range of applications and situations.
See table at the end of this manual for default configuration
parameter settings.

Before entering the programming mode, make sure that
the appliance is in service mode.

In case no button is pressed in a period of 5 min, the
control panel will automatically return to the service mode;
any changes made will NOT be saved!
1.
Press the scroll  button and hold it for 6 sec until the
display shows:
2. Within 10 sec, press the up  button; the display will
show:
•
Press the up  or down  button to set the units of
measure (Metric or US) .
3.
Press the scroll  button again; the display will show:
•
Press the up

or down

button to activate the
maintenance reminder function by setting the
maintenance interval, or deactivate the maintenance
reminder function
.
4.
Press the scroll  button again; the display will show:
•
Press the up  or down  button to set the
exchange capacity per litre of resin .
5.
Press the scroll

button again; the display will show:
•
Press the up  or down  button to set the age
correction factor (%/year) to compensate for capacity
loss of the resin due to aging.
6.
Press the scroll  button again; the display will show:
•
Press the up  or down  button to set the volume
of resin .
7. Press the scroll  button again; the display will show:
•
Press the up  or down  button to set the number
of days between regenerations .
8.
Press the scroll  button again; the display will show:
•
Press the up  or down  button to set the length
of the regeneration cycle .
•
Press the scroll

button again to advance to the next
regeneration cycle.
Eco
Refill Cycle 1
Brine preparation Cycle 2
Backwash Cycle 3
Brine draw/slow rinse Cycle 4
Fast rinse Cycle 5
9.
Press the scroll  button again; the display will show:
•
Press the up  or down  button to set the
regeneration mode :
−
Dlyd/Immd : when the remaining capacity equals
the reserve capacity, a delayed regeneration is
started at the programmed time of regeneration;
however when the remaining capacity equals 0
before the programmed time of regeneration is
reached, an
immediate regeneration is started.
−
Immediate : when the remaining capacity equals
0, an immediate regeneration is started.
−
Delayed : when the remaining capacity equals the
reserve capacity, a delayed regeneration is
started.
10.
Press the scroll

button again; the display will show
(only when the regeneration mode was set to 'Delayed' or
'Dlyd/Immd'):
•
Press the up  or down  button to set the time of
regeneration .
11. Press the scroll  button again; the display will show:
•
Press the up  or down  button to activate or
deactivate the salt level alarm function .
Cycle 1: XXX sec
System Check
Regen @ 2:00
Units: Metric
Resin: XXX liters
Age corr.: 1.0 %
Override: 7 days
Regen:Dlyd/Immd
Salt alarm: ON
ExCap: 5.1 °f M3/L
MaintInt: 24 mths