Erica Synths Drum Sequencer, User Manual

Page: 10 / 18

A+M
M
A+M
M
A+M
M
IN 1 IN 4 IN 7
IN 2 IN 5 COMP AMT
IN 3
IN 1 IN 3
IN 2 IN 4
IN 5
IN 6
IN 7 AUX OUT
MAIN OUT
IN 6 RELEASE
PARAM 1 PARAM 1
DRY/WET DRY/WET
CV IN
SELECT
SAVE
SELECT
SAVE
OUT L CV IN OUT L
IN 1 OUT R IN 2 OUT R
PARAM 2 PARAM 2
FX1 FX2
PARAM 1
SAVE
LEDs
PARAM 2
DRY/WET
SELECT
CV IN
IN 1
OUT L, OUT R
Adjust the first parameter of the effect
Push and hold the SAVE button for 2" to save the parameter and
dry/wet settings with the effect. To recall parameter and dry/wet
settings, push the SAVE button promptly. All three effect select
LEDs will blink once to confirm setting recall. Now, if you turn
the parameter knobs to alter the settings, the LEDs will flash
once, when the saved position of the potentiometer is reached.
Only then parameter changes will take effect.
Adjust the second parameter of the effect
These are the effect indicator LEDs. They indicate one of 8 selected
effects in binary code. Please, refer to the Effect table below!
This is dry/wet control potentiometer
This is effect select button. Push it promptly to navigate thru effects.
To assign CV input to control one of the parameters or dry/wet setting,
push and hold the button for 2”. The first effect indicator LED will start
to flash, indicating that the CV is assigned to the first parameter. Push
the button repeatedly to assign the CV input to the 2nd effect or to
dry/wet control.Push the SAVE button to confirm
This is the assignable CV input
This is the audio input. The effects are designed to add
stereo spread to the mono input signal
These are left and right outputs. We highly recommend
to use the module with the stereo mixer
FX DRY/WET PARAM 1 PARAM 2
MONO DELAY
STEREO DELAY
HI PASS DELAY
BIG REVERB
SATURATED REVERB
STALKER REVERB
RIPPER
DUAL PITCH SHIFTER
DRY/WET
DRY/WET
DRY/WET
DRY/WET
DRY/WET
DRY/WET
DRIVE
DRY/WET
TIME
TIME
TIME
SIZE
SIZE
TONE
CRUSH
SHIFT 1
FEEDBACK
FEEDBACK
HI PASS FILTER
TONE
TONE
FEEDBACK
DELAY TIME
SHIFT 2
IN1 – IN7 potentiometers adjust signal
level on relevant inputs.
LEDs give visual feedback on signal level
after input potentiometers. LEDs lit when
signal reaches 5Vptp
Use switches to assign the first three inputs
to Main or to both Main and Aux Send outputs
These are the Audio inputs. The input signal
can be boosted for +6dB with the level
potentiometer knobs full CW
Adjust compression amount to your taste!
Note that maximum compression amount
settings may result in more noisy output
Adjust compressor release time to your taste!
This is the effects send output
This is the main output of the mixer
IN1–IN7
A+M
IN
AUX OUT
MAIN OUT
COMP AMT
RELEASE