GAIN 1
GAIN 2
CV
LVL 1
CV
LVL 2
GAIN
CV1
DRIVE
CV1
DRIVE
CV2
GAIN
CV2
IN
1
OUT 1
IN
2
OUT 2
DRIVE 1
DRIVE 2
MODE 1
MODE 2
DUAL DRIVE
IN 1
IN 6
IN 3
IN 1
IN 3
IN 5
A OUT
IN 2
IN 4
IN 6
M OUT
IN 5
IN 2
IN 4
A+M
M
A+M
M
A+M
M
IXER LITE
Adjust Gain for the each section manually
Mode switch allows you to select one
of three overdrive flavours – it connects
drive circuits in several combinations
Adjust overdrive level for each
section manually
These are CV level attenuators. Note that
they affect both CV (Gain and Drive) inputs
simultaneously
These are Gain and Drive CV inputs
IN1 and IN2 are audio inputs of both overdrive
sections. Please note, that if nothing is patched
in IN2, it is normalled to OUT1 and both sections
automatically are connected in series
LEDs give visual feedback on overdrive level
These are outputs of both overdrive sections
GAIN1
,
GAIN2
MODE1
,
MODE2
DRIVE1
,
DRIVE2
CV LVL 1
,
CV LVL 2
GAIN CV IN
,
DRIVE CV IN
IN 1
,
IN 2
OUT 1
,
OUT 2
IN1 – IN6 potentiometers adjust
signal level on relevant inputs.
LEDs give visual feedback on signal level
after input potentiometers. LEDs lit when
signal reaches 5Vptp
Use switches to assign the first three inputs
to Main or to both Main and Aux Send outputs
These are the Audio inputs. The input
signal can be boosted for +6dB with the level
potentiometer knobs full CW
Use a small screwdriver to access the
top trimmer potentiometer and set the compression
amount to your taste! Note that maximum
compression amount settings may result
in more noisy output. The bottom trimmer
potentiometer adjusts compressor release.
This is the effects send output
This is the main output of the mixer
IN1–IN6
A+M
IN
TRIMMER POTENTIOMETERS
A OUT
M OUT
Summary of Contents for Drum Sequencer
Page 12: ......
Page 13: ......
Page 14: ......
Page 15: ......
