Ergomotion 40+ Series, Owner'S Manual

Page: 7 / 14

10 11
You may now connect your headboard to the attachment plates
using the remaining short bolts and nuts to secure it to the
brackets. The heads of the bolts will face outward. Use a 9/16"
(14mm) socket and 1/2" (13mm) wrench to tighten the bolts.
headboard bracket installation guide (optional)
STEP 1 STEP 2
STEP 3
a.) Align the hole in the bracket to the brass sleeve into which the
leg threads. Hold the bracket in place and screw the leg into the
base until it is snug. DO NOT OVERTIGHTEN. Too much force
may cause the leg to spin freely.
b.) Align the tab with the hole in the frame (located towards the
foot of the base) and use a short bolt and nut to secure the
bracket. Make sure the bolt is tight.
Attach the plastic spacer and T-Bracket.
a.) Measure the distance between the mounting holes on the
headboard and install the spacer and attachment plate to
accommodate the headboard.
b.)
To install the plastic spacer and attachment plate, you will need
(2) long bolts and (2) nuts. Place the spacer and attachment
plate in the desired location and slip the bolts through the holes
with the head of the bolt facing outward. Position the bolts
diagonally on the spacer. Use the 9/16” (14 mm) socket and
wrench to tighten the bolts.
Headboard Brackets are an optional accessory and are not included.
A 9/16” (14 mm) & 1/2” (13 mm) socket and crescent wrench are necessary to complete installation.
A Y-Cord is included with the base. Not available on Queen, Full or Full-Long size bases.
The Y-Cord connects the two control boxes to a single remote for the synchronization of two bases.
Locate the control box underneath the base. Plug end of y-cord
into wired remote port on the control box. Repeat for other end of
cord and second control box.
Once the remote has been connected to the control box with the
y-cord, plug bases into power outlet and test all functions.
Plug remote into Y-Cord
Unplug bases from power source.
STEP 3
STEP 2
STEP 1 STEP 4
syncing two bases (optional)
Remote
Y-Cord
Control Box
Bed A
Control Box
Bed B