Ergofix BV 20 C, Operating Instructions Manual

Page: 18 / 32

BV 20 C
16
4. INSTALLATION AND ADJUSTMENT
1 Having unpacked the box, you should check if all the accessories are
complete.
2 The machine should be mounted on solid wooden or steel benches and
fastened with bolts and nuts (see Fig. 2), to prevent the machine from
vibrating when it starts running; this will have an effect on the accuracy of its
operation.
3 Please use a leveller to level off the machine while
installing it.
4 During installation, the anti-rust grease applied on the slide surface and non-
painted area should be cleaned thoroughly with kerosene or turpentine.
5 Fasten the column for drilling and milling into the hole at the rear of
machine’s bed, its lower end should touch the working platform. Then, adjust
the drilling/milling box position and fasten the column.
6 Clean the cutting spindle box with kerosene or gasoline, then, fill the filtered
machine oil.
7 Fill machine oil fully to the oiling points and lubricating surfaces in various
parts of the machine, check if the operational levers are smooth and reliable.
Adjust, if unsatisfied.
8 Before the start-up of the machine tool, you must make a thorough check
over all the electric parts of the motor so as to avoid the current leakage and
any other accidents because of the damage of electric circuit during the
transportation.
9 On the first starting of test run, you should select the lowest step of running
speed and start the machine tool to run for 20 minutes to see if there is any
unusual phenomenon with it, if there is not, you can increase the running
speed gradually. Initially try the cutting function and then drilling and milling.
10 The change of spindle rotation and feed should be done after the machine
fully stops.
5. OPERATION AND MAINTENANCE
Spindle box for cutting
Rotate the lever (18) (19) to change the speed according to spindle speed change
chart, in this mode, six spindle speeds can be gained. Please note that to change
the spindle rotation speed, the machine should first be stopped.
Rear cover
Rotate handle to open the cover, the four different feed and thread pitches cutting
can be gained by replacing the set of change gears attached with machine
according to the gear chart.
Feed box
Press the button (3) to start the spindle and button (2) to control its rotation
directions and button (4) to stop.