19
Operators Manual ES-643P
Suction
nozzle
Wing
screw
Fastening
collar
Wing nut
•
Make sure the engine is switched off (set the ignition
switch to „OFF“) and switch off the Pellenc battery.
Move the suction nozzle to the highest position.
Remove the suction nozzle from the appliance by
unscrewing the two wing nuts and the wing screw on
the safety switch.
•
Attach the mounting flange of the suction hose to the
turbine housing accordingly. Push the suction hose
onto the mounting flange and tighten the hose clamp.
• To change between suction nozzle and suction hose,
always switch off the engine and set the ignition switch
to „OFF“ and pull off the bowl.
DANGER:
Never lock or bypass the safety switch on the
turbine housing.
Replace defective switch before restarting.
Never start or run the engine without the suc-
tion nozzle or without the suction hose.
Risk of serious injury.
Pieces of clothing and limbs
could be sucked in.
Fitting the suction hose (accessories)
Suction hose
Fastening collar
wing nut
Wing screw
Suction Hose
mounted
In case of dirt/blockage
Switch off the machine and the battery and
remove the ignition key.
To do this, remove the two outer wing nuts and unscrew
the wing screw in the middle, on the safety switch, com-
pletely. Now remove the fastening collar for the suction
nozzle and the suction nozzle.
Loosen the dirt/blockage with a wooden stick or similar.
Do not grasp into the turbine housing with your bare
hands; be sure to use gloves.
Once all coarse dirt has been removed and the turbine
can rotate freely again, refit the suction nozzle and let the
unit run. It is now ready for use again.
Note:
Regular inspection and cleaning of the turbine housing
maintains the high suction power of the unit.
