14
Operators Manual ES-640PIA
Operating instructions
Before using your leaf and waste vacuum cleaner, make
sure that
•
the unit is placed on a firm, level surface,
• the collecting bag is hooked in,
• the suction trunk is adjusted to the correct height,
• the fuel tank is full,
• the throttle lever is set to “STOP/MIN”.
Start the machine:
• Set the choke lever to “CLOSE”,
• Set the fuel tap to “ON”,
• Set the stop switch to “ON”,
• Pull the starter rope - engine running -,
• Set the choke lever to “OPEN”,
• Slowly set the throttle lever to “full throttle”.
Shutting down the machine
• Set the throttle lever to “STOP/MIN,
•
Set the stop switch to “Off”,
• Set fuel tap to “OFF”.
In an Emergency Situation
• Remove drive,
• Set the stop switch to “OFF”.
Warning:
Highly flammable substances (e. g. embers,
hot barbecue coal) can ignite when you hit a
hot surface.
Risk of injury due to light
flammable substances.
Installing the collecting bag
• Slide the opening of the bag over the ejection sheet.
Tighten the catching bag to the ejector channel with
the tension strap.
• There are 4 tabs on the top of the bag. These tabs are
pulled over the guide rail from the outside and attached
to the 4 brass coloured bolts.
Empty the collection bag
• Stop the engine before opening the collecting bag.
• Open the zipper or toggle fastener on the collecting
bag and remove sucked-in material. Wear protective
gloves.
• Close the zipper or toggle fastener on the catch bag.
DANGER:
Never operate the leaf and waste suction
unit without a collection bag.
Stop the engine before opening or remov-
ing the bag.
Risk of serious injuries.
