EG_GenLoc31e_988_CL_002_UK
Page 6 / 22
Descriptions and non-contractual illustrations in this document are given as an indication only.
ERCO&GENER reserves the right to make any modifications.
2 COMMANDS
2.1 General
commands
2.1.1
ATI8 – Display application version and build information
This command will display the version and build information of the application.
Syntax: ATI8
Example :
Command Possible Responses
Notes
ATI8
GenLoc31e V0.73 Jun 19 2006 14:32:38
OK
Display application version
and build information
2.1.2
AT+HELP – Display list of available general commands
This command will display a list of the available general commands. The list includes certain Wavecom
commands which have been recreated by the application in order to be compatible with the GenLoc31e
hardware and the original Wavecom commands (example: AT+WGPSPOS).
Syntax: AT+HELP
Example :
Command Possible Responses
AT+HELP
ATI8......................Display product software version and build information
AT+WGPSNMEA=(0-1),(0-5),..Activate display of unsolicited GPS NMEA frames
AT+WGPSPOS................Display current GPS coordinate information
AT+SHOWPOS=(0-240)........Display GPS information every n seconds. (0=disable)
AT+ERRORSTAT=(0-1)........Display frame errors and total frames received (0=NMEA,
1=UBX)
AT+WIOR=(0-3).............Display logic level at input 0-2 or motion detector (3)
AT+WIOW=0,(0-1)...........Set logic level on open-collecter output. 0=low, 1=high
AT+WIOW=1,(0-1)...........RS232 interface: 0=enabled, 1=disabled
AT+WIOW=n,(0-1)...........UART2 mode: n=7/8. 0=normal(DSR/DTR), 1=RxD/TxD diverted
to DSR/DTR
AT+WGPSM=0,(0-1)..........GPS module power: 0=off, 1=on
AT+WGPSM=1,(0-1)..........GPS module reset: 0=reset, 1=normal
AT+WGPSM=3................GPS module Software and Hardware versions
AT+WGPSRAW................Send a raw UBX data stream to the GPS module
AT+WGPSANT=(0-2)(,[mode][mon])..GPS antenna configuration
AT+HELPUBX................Display list of UBX commands
OK
Note: Display general command list
