Erco & Gener Genloc 31e, Command List, Page: 11 / 22

EG_GenLoc31e_988_CL_002_UK Page 11 / 22
Descriptions and non-contractual illustrations in this document are given as an indication only.
ERCO&GENER reserves the right to make any modifications.
<state>
0 UART1 RS232 interface is enabled (default)
1 UART1 RS232 interface is disabled (the RxD remains active allowing the unit to
continue to receive commands)
<mode>
0 Normal (default)
1 UART 2 RxD and TxD redirected to UART1 DSR and DTR (does not require reset and
external mode)
Examples :
Command Possible Responses Notes
AT+WIOW AT+WIOW=(0,1,7,8),(0-1)
OK Display syntax
AT+WIOW=0,1
OK
Open-collector output is
set high
AT+WIOW=1,0
OK UART1 RS232 interface is
enabled
AT+WIOW=7,1
OK UART2 RxD/TxD
redirected to UART1
DSR/DTR
2.1.9 AT+WGPSANT – GPS antenna configuration
This command manages the GPS antenna configuration.
Syntax: AT+WGPSANT=<type>[,<mode>][,<mon>]
Response syntax: +WGPSANT: <type>,<mode>
: <type>,<mon>
: <type>,<status>,<presence>,<voltage>
Unsolicited response syntax: +WGPSANT: <type>,<status>,<presence>,<voltage>
<type>
0 Antenna configuration (see <mode> below)
1 Antenna monitoring management (see <mon> below)
2 Antenna status (see <status> below)
<mode>
0 0v (antenna not powered)
1 3v internal (default) (antenna powered)
<mon>
0 Monitoring is deactivated (default)
1 Monitoring is activated
<status>
0 Antenna is not powered
1 Antenna is powered
Note : In the case of a short circuit, the hardware protection disconnects the antenna,
causing an open circuit. After a 10-second delay the antenna is re-powered.
<presence>
0 No antenna connected
1 Antenna connected