Erbauer ERB807A, Manual, Page: 13 / 20

800W PENDULUM JIGSAW
WORKING HINTS FOR YOUR
JIGSAW
If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run no load for 2-3 minutes to cool
the motor. Avoid prolonged usage at very low
speeds.
MAINTENANCE
Your power tool requires no additional
lubrication or maintenance. There is no user
serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth.
GENERAL
Always use a blade suited to the material and
material thickness to be cut. Always ensure the
work-piece is firmly held or clamped to prevent
movement. For easier control, use low speed to
start cutting, then increase to correct speed. Any
movement of the material may affect the quality
of the cut. The blade cuts on the upward stroke
and may chip the uppermost surface or edges
of your work piece. When cutting, ensure your
uppermost surface is a non visible surface when
your work is finished.
CUTTING LAMINATES
Use a fine tooth blade when cutting most
laminates and thin wood materials. To reduce
edge chipping, clamp pieces of waste wood at
both ends on both sides and cut through the
wood during cutting.
CIRCLE CUTTING
Do not use the pendulum action when cutting
tight circles or angles.
METAL CUTTING
Use a finer tooth blade for ferrous metals and a
coarse tooth blade for non-ferrous metals. When
cutting thin sheet metals always clamp wood
SFX-ERB807A-M-050920.indd 13 2005-9-20 15:40:04