Erbauer ERB807A, Manual, Page: 12 / 20

10. BASE PLATE ANGLE ADJUSTMENT
Using an Allen key, loosen the bolts securing the
base plate (See Fig 8). For preset angles, slide
the base plate fully to the front and rotate so the
fingers on the base plate and housing interlock
at the desired angle (0,15,30,45) (See Fig 7). For
other mitre angles, slide the base plate
partially to the front and rotate to your desired
angle (use a protractor scale). For 90
o
angle, slide
the base plate fully to the rear. Following one
of the above procedures, hold the base plate in
position and firmly tighten the bolts to clamp the
base plate at that angle. Finally, check the angle
and ensure the base plate is firmly clamped. The
angle markings on the base plate are accurate for
most general purposes but it is recommended for
accurate work to set the angle with a protractor
and make a test cut on other material.
11. INSTALLING THE PARALLEL GUIDE
Slide the parallel guide arm through both fixing
slots to achieve the required cutting distance and
tighten both screws to lock into position.
12. DUST EXTRACTION ADAPTOR
The adaptor slides inside the base plate and
locked in position by a clip into the base plate
(See Fig 9). The adaptor must then be connected
to a suitable external dust extraction machine.
The connection can be on the outside dia 40mm
or inside dia 36-34mm of the adaptor.
13. PROTECTION FINGER
This finger is located in front of the blade holder.
Whilst working, it will help prevent accidental
contact with moving blade (See Fig 10).
14. DUST BLOWER AIR HOLE
This is a small aperture located underneath the
housing just behind the blade guide. Ensure this
is kept clean to allow the air flow to continually
blow dust away from the cutting area.
Fig 9
Fig 7
Fig 8
��
Fig 10
SFX-ERB807A-M-050920.indd 12 2005-9-20 15:40:03