Erbauer ERB807A, Manual, Page: 11 / 20

800W PENDULUM JIGSAW
Chart 2
6. TOOLFREE BLADE HOLDER
You can only use the Bayonet type of blade
shown as (12) in the main diagram. To open the
blade holder rotate the ring anti-clockwise (jigsaw
upside down) and hold in position (See Fig 5).
Then fully insert the blade into the blade holder
slot with blade teeth facing forward and release
the ring, which will self rotate and clamp over the
top of the blade. Push the blade into the blade
holder again to ensure it is locked in position.
Ensure the edge of the blade is located in the
groove of the blade guide (See Fig 4). To remove a
blade, hold the blade and rotate the blade holder
ring anti-clockwise then lift out the blade (blade
could be spring ejected).
Warning: blade teeth are very sharp.
For best cutting results ensure you use a
blade suited to the material and cut quality you
need.
7. BLADE GUIDE
Ensure the blade is located and runs smoothly in
the groove (See Fig 4) otherwise the pendulum
function will not work correctly and the blade will
not be supported during cutting.
8. BLADE GUARD
The blade guard (8) should always be in place
when the jigsaw is used (See Fig 6).
9. BASE PLATE
Adjusting the angle of the base plate enables
bevel cutting. The base plate must always be held
firmly against the material being cut to reduce
saw vibration, blade jumping or blade breakage.
Fig 4
Fig 5
Fig 6
PENDULUM SETTINGS
0
Thin materials, Fine cuts, Tight curves.
1 Hard materials, (eg steel & chipboard)
2 Thick materials (eg wood & plastic)
3 Fast cuts (eg softwood). Cutting in the
direction of the wood grain.
SFX-ERB807A-M-050920.indd 11 2005-9-20 15:40:02