Erbauer ERB110SSW, Manual

Page: 7 / 24

70W SCROLL SAW
ing thrown in to the eyes, which can result in severe eye damage. Always wear safety
goggles before commencing power tool operation.
Warning:
Always wear safety goggles or face shield. Install blade with teeth pointing down
towards the table. Keep fingers a safe distance from the blade.
Never leave the scroll saw work area with the power on. Adjust blade tension by hand
(not with a tool) before turning on. Maintain control of the workpiece at all times, hold
firmly against the table.
VIBRATION
The European Physical Agents (Vibration) Directive has been brought in to help reduce
hand arm vibration syndrome injuries to power tool users. The directive requires power
tool manufacturers and suppliers to provide indicative vibration test results to enable
users to make informed decisions as to the period of time a power tool can be used
safely on a daily basis and the choice of tool.
Further Advice can be found at www.hse.gov.uk
Vibration total values (triax vector sum) determined according to EN 61029:
Work mode description 1
(with flexible shaft )
Vibration emission value ah = 0.14 m/s²
Uncertainty K = 1.5 m/s²
The declared vibration emission value should be used as a minimum level should be
used with the current guidance on vibration.
Calculating the actual period of the actual period off use can be difficult and the HSE
website has further information.
The declared vibration emission been measured in accordance with a standardised test
stated above and may be used to compare one tool with another
The declared vibration emission value may also be used in a preliminary assessment
of exposure.
Warning:
The vibration emission value during actual use of the power tool can
differ from the declared value depending on the ways in which the tool is used
dependant on the following examples and other variations on how the tool is used:-
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring it is sharp and in good condi-
tion.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately
managed