Erbauer ERB096HTG, Operating Instructions Manual

Page: 11 / 20

2000W HEAT GUN
OPERATING INSTRUCTIONS
Note:
Before using the tool, read the instruction
book carefully.
BEFORE USING THE TOOL
Before starting the job it is advisable to test the
work piece for the ideal temperature to use.
The description below gives an indication of the
likely heat settings required but always start with
the low heat setting and use the lowest heat set-
ting possible to complete the task.
The distance between the nozzle and the work
piece will vary according to the material being
worked on but this should always be at least
50mm (2inch) or more on either heat setting.
All applications, with the exception of removing
paint from the window frames, can be per-
formed without using a nozzle, however for best
results nozzles are recommended.
OPERATION
Ensure that the mains voltage is correct!
The voltage of the power source must agree
with the value given on the nameplate of the
unit.
1. SWITCHING ON/OFF
SWITCHING ON (SEE Fig 1):
Set the switch (5) to
I
or
II
. Press any of the
buttons to start up the LCD display. Before any
further operation, the LCD always displays the
temperature and air flow status of the latest
operation. Then set the desired temperature and
air flow as required.
SWITCHING OFF (SEE Fig 2):
To switch off, slide the on/off switch (5) to the
stop at position ‘O’.
When working for extended periods at high
temperature settings, allow the unit to cool by
running in the cold air setting ‘I’ before switching
off.
2.THERMAL PROTECTION SWITCH OFF
If the heating element is overloaded as a result
of restricted airflow, the heating element will
switch off automatically. The heatgun blower
Fig 1
Fig 2
5