24
Care & maintenance
WARNING!
Always switch the product off, disconnect the product from
the power supply and let the product cool down before performing
inspection, maintenance and cleaning work!
Only perform care and maintenance work according to these instructions!
All further works must be performed by a qualified specialist!
Clean
1. Clean the product with a dry cloth. Use a brush for areas that are hard to reach. In
particular clean the base plate, switches and air vents after every use with a cloth
and brush.
2. Remove stubborn dirt with high pressure air (max. 3 bar).
3. Check for worn or damaged parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the product again.
Do not use chemical, alkaline, abrasive or other aggressive detergents or
disinfectants to clean this product as they might be harmful to its surfaces.
Maintenance
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool.
Before and after each use, check the product and accessories (or attachments) for
wear and damage. If required, exchange them for new ones as described in this
instruction manual.
01
Power cord
If the replacement of the supply cord is necessary, this has to be done by the
manufacturer or his agent in order to avoid a safety hazard.
160W Corner sander_MNL_EDLS160_TPS_GB_V1_V10518_20180607.indd 24
6/7/18 10:48 AM
