21
03
Dust extraction (Fig. B, C, D)
The product can be used with the dust collection box (2) or an external dust extraction
device.
Dust collection box
1. Attach the dust collection box (2) to the dust extraction outlet (3). Fig. B.
2. Pull the dust collection box (2) off to remove it.
3. To empty the dust collection box, push the release latches (2a) on both sides
and open the box. Fig. C. Assemble the dust collection box in reverse order after
cleaning.
External dust extraction device
1. Attach a proper dust extraction device, e.g. a suitable vacuum cleaner attachment
(Ø35mm), to the dust extraction outlet (3). Fig. D.
02
Sanding paper (Fig. A)
Always remove dust and chips from the sanding base plate (4) before
attaching sanding paper (9) to reduce the wear of sanding base plate and
sanding paper.
Choosing the right sanding paper
Sanding paper is available with different grain sizes (grit) and for different materials.
The grain size is indicated with a number on the reverse of the sanding paper, the
higher the number, the finer the grain size.
Grain size Class
Application
< 80
Coarse Removal of paint and varnish, preparation of rough surfaces.
80-120
Medium For face sanding and smoothing small irregularities.
>180
Fine
Finishing, cleaning plaster and water stain from wood.
• Only use suitable sanding papers in terms of application and size. Do not use
papers that are bigger than the base plate of the product.
• Replace worn or damaged sanding papers immediately.
• Start with a coarse sanding paper and finish with a fine-grained one to achieve a
satisfactory result.
• Do not use the same sanding paper on different materials, e. g. do not use the
sanding paper that has been used for sanding metal to sand wood. Small metal
particles remaining in the sanding paper will lead to scratches.
• We recommend using sanding papers with a hole pattern for sufficient dust
extraction.
The base plate (4) of the product has hook-and-loop system.
1. With the hook-and-loop system, sanding paper is simply removed by pulling off.
2. Align the hole pattern of the new sanding paper (9) with the one in the base
plate (4) to ensure efficient dust extraction if available.
3. With the hook-and-loop system, sanding paper is simply pressed on the base
plate.
160W Corner sander_MNL_EDLS160_TPS_GB_V1_V10518_20180607.indd 21
6/7/18 10:48 AM
