ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: [email protected]
Instruction manual
03267-03272
Issue: 01/2019
Changes, print, punctuation and other errors reserved!
Page 7
GB - INSTRUCTION MANUAL
Table of contents
1. Safety instructions
2. Product description
3. Designated use
4. Restrictions of use
5. Technical data
6. Noise emission values
7. Important information for initial operation
8. Operation instructions
9. Service and replacement parts
10. Warranty
11. Disposal
12. Legal information
13. Declaration of conformity
Page
7
8
8
8
8
8
8
8
9
9
9
9
10
Read this material before using this product. Failure to do so can result in serious injury. KEEP THIS MANUAL. When giving
this machine to third parties, always include this manual. We do not accept any liabilities for accidents or damages that
result from misuse.
Removal/Alteration of any safety devices or of the machine in general will result in the
loss of warranty. The buyer assumes all risk and liability arising out of his or her repairs/alterations to
the original product or replacement parts thereto, or arising out of his or her installation of replacement
parts thereto.
1. SAFETY INSTRUCTIONS
Never overload the bottle jack.
Never exceed the maximum lifting height of the hydraulic jack.
Make sure that the surface on which you use the hydraulic jack is level and stable. Never use the hydraulic jack on surfaces
that can cave in or collapse.
Always keep your work area well lit, clean and free of obstacles.
Never lift a vehicle when there are people inside. Stop the engine of the vehicle and pull the handbrake. Make sure that the
vehicle can not roll or slip away. For vehilcles with manual transmission use the 1st gear or the reverse gear. For vehicles with
automatic transmission use positon „P“.
Always use chock blocks (A).
Never board the vehicle and/or start its engine as long as it is suspended on the hydraulic jack or on support stands.
Position the hydraulic jack so that it will lift the vehicle using the designated supporting points as indicated by tha manufacu-
rer of the vehicle. Make sure that those points are not rusty, dirty, oily or compromised in any other way.
Make sure that the lifting surface of the hydraulic jack is positioned in the center of the supporting points on the vehicle.
Failure to do so can result in the hydraulic jack tipping over and potentially serious injuy or even death!
Make sure the vehicle can not move in any way when trying to lift it with the hydraulic jack. Heavy traffic (when using the
hydraulic jack near or on a road) may cause significant vibrations - wait for the right timig if necessary.
Positon the hydraulic jack so that you do not have to put any part of your body below the vehicle when lifting it.
Never crawl under a vehicle that is being lifted by a hydraulic jack. You MUST use a minimum of 2 support stands per axle
(C) and make sure that the vehicle rests safely on those stands before you can crawl under the vehicle and make repairs!
Pay close attention to the hydraulic jack while lifting. Immediately stop lifting the vehicle if you notice anything unusual (eg.
unstable jack, moving vehicle, etc).
Make sure that there are no objects or persons under the vehicle before you lower it.
Never change the setting on the safety valve! It is designed to stop the lifting process when the jack is overloaded.
