53
Other
52
Other
Table of supported modes
Power save function
This reduces power use.
When the monitor is in power save (sleep)mode,this can be seen by the colored
power light that stays on,and the screen will come back on when you click the mouse
or any key.
This function works only if it is connected to a computer with a power save function.
Power save function works as follows.
c o l o r
g r e e n
o r a n g e
Maximum power usage
3 7 W
2W
Power save function works as
f o l l o w s .
Power save mode's sleep status
R e s o l u t i o n
horizontal frequency (Khz)
vertical frequency (Hz)
31.47
60
640 × 480
37.86
72
37.50
75
720 × 400
31.47
70
35.16
56
800 × 600
37.88
60
48.08
72
46.88
75
48.36
60
1024 × 768
56.48
70
60.02
75
1280 × 1024
63.98
60
79.98
75
This equipment has been tested and found to comply with the limit for a Class B
digital Device pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. this equipment generates, uses, and can radi-
ate radio frequency Energy and, if not installed and used in accordance with the
instructions, If this equipment does cause harmful interference to radio communi-
cations. However, there is on guarantee that interference will not occur in a partic-
ular installation. If this equipment does cause harmful interference to radio or tele-
vision reception, with can be determined by turning the equipment off and on, the
user is encourage to try to correct the interference by one or the following meas-
u r e s :
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
Receiver is connected.
- Consult the dealer or an experience radio TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device comply with part 15 of the FCC Rules. Operation is subject to the following two
c o n d i t i o n s ;
(1) This device may not cause harmful interference, and
(2) This device must accept any interference that may cause undesired operation.
