Maintenance
Before cleaning the Docking Station, unplug the Adapter Plug to prevent electric shock.
Regularly wipe the magnetic connector on the Adapter and the charging port of the Docking
Station with a dry cloth to keep it dry and clean.
It is recommended that you remove and clean these parts regularly:
When opening the Powerhead to replace or clean the parts, be careful of sharp parts which
could cause injuries.
It is recommended that the Roller be replaced every 6-12 months. After several uses, the
Roller Replacement Indicator light will turn orange. After replacing the Roller, press the
Power button, then press and hold the Self-Clean button for 5 seconds and the Indicator
light for Roller replacement will turn off. The Roller Brush and Scraper can also be replaced
when needed.
When there is wastewater in the Docking Station, please empty it in a timely manner to
prevent odors. When lifting it, please do not shake it too much to avoid spilling of wastewater.
To prevent blockage, regularly clean the clean water Filter which is at the base of the Docking
Station. Pull out the small round Filter, open the Filter Cap and clear the inside of the Filter.
Then close the Filter Cap and replace it by pushing the Filter back into the base of the
Docking Station.
If the appliance has not been used for a long time, please empty both the clean water tank
and wastewater tank in the Docking Station.
Roller: Open the Powerhead Cover, press the orange Roller Lock Button and lift out
the Roller.
Roller Brush: Open the Powerhead Cover, pull out the small black Clip inside the
Powerhead to release the Roller Brush.
Scraper: Turn the Powerhead over so you are facing the under side of the appliance.
While pulling down on the Lock Release Button, slide out the Scraper at the same time.
Docking Station
Filter
Filter
Filter Cap
Roller
Roller Rod
Roller Lock
Button
Roller Brush
Scraper
Top of Powerhead
Underside of Powerhead
Lock Release
Button
Clip
