Remove the fully charged
Sweep
MOP
from the Docking Station.
Lift top cover of the Powerhead by pressing orange Lever and lifting up.
Connect the small orange magnetic Roller Lock Button to one side of the Roller, while
sliding the other end of the Roller onto the Roller Rod.
Push the Roller firmly down so that it locks into place.
The Roller Lock Button will pop out and appear through the square hole on the
side of the Powerhead.
Note: When you want to remove the Roller for cleaning and replacement, push the Roller
Lock Button on the side to release the Roller.
Preparation for use
Charge the appliance by attaching the Adapter Plug to the magnetic port at the back of the
Docking Station and plugging the other end into a 110 volt electrical outlet. Stand in front of
the Docking Station and place the assembled
Sweep
MOP
straight down onto the Docking
Station and ensure it locks in place on top of the Charging Column.
It will charge automatically, during which time the top Indicator light on the Handle will be
orange. When the charging is completed (in about 2 hours) the charging will automatically
stop, and the Indicator light will turn white. If the
Sweep
MOP
has a low battery, the indicator
flashes orange then turns off after 3 seconds. You must then charge the
Sweep
MOP
before
using it.
Before using the
Sweep
Mop
for the first time or using after an extended period of non-use
(10 days), the Roller must be immersed in room temperature water and soaked for about 2
hours, until completely soft. Squeeze out excess water out of the Roller. This does not need
to be done every time you use the
Sweep
MOP
if it is being used frequently and the Roller
remains wet. Dry Roller will cause damage to the product.
Powerhead
Sponge Roller
Powerhead Cover - open
Roller Rod
Roller Lock Button
Sponge Roller Installation
