-16-
PUTTING INTO OPERATION
If the cabinet has been sharply tilted while being sited or for
mounting of accessories, it must be left to stand for at least three
hours before being started to allow the lubricating oil to settle in
the compressor.
Failure to do so can cause total destruction of the compressor
refrigerating system.
Check that the voltage on the identification plate is the same as
that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE
REFRIGERATOR WILL HAVE TO BE CONNECTED
IS TO BE PROTECTED BY A VERY SENSITIVE
DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA); IT IS
ALSO TO BE LINKED TO THE GENERAL EARTHING
PLANT.
Follow the manufacturer’s instructions to install the unit, using qualified personnel
and complying with the electrical regulations for the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable
for this.
The manufacturer disclaims all responsability for any damage to people or
things due
to incorrect observance of this rule.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords, adapters or multiple socket outlets to connect
the counter. DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught or stepped on,
away from water and the other liquids and heat sources and must not be damaged.
In case of breakage of the power cable of the cabinet, it must be replaced by the manufacturer or by
instruction it change of it. The plug must still be accessible even after installing the unit.
PERIODIC MAINTENANCE
WARNING! ANY WORK CARRIED OUT ON THE APPLIANCE BY THE USER
STRICTLY REQUIRES THE POWER PLUG BEING DISCONNECTED FROM THE
MAINS SOCKET.
WARNING!
Use protective shoes and gloves during maintenance operations.
Inspect the power cable to see if it is damaged. If the power cable is damaged, do not use the
appliance and try to repair it: it must be replaced by the manufacturer or its customer service
department or by a similarly qualified person, in order to prevent any risks. No protection (grill
or guard) should be removed by unqualified personnel and strictly avoid operating the appliance
with these protections removed.
OUTER CLEANING
For a good preservation of the cabinet’s body
a periodical cleaning is necessary
.
EXTERNAL BODY
: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES
: Wash with warm water and mild detergent, rinse well and dry
with soft cloth. Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL
: Wash with warm water and mild detergent, rinse well and
dry with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES
: Only use products specifically designed for glass cleaning; It is not advisable
to use ordinary water which can leave a film of calcium on the surface of the glass.
