X K 3 1 9 0 - A 1
+P
communication mode parameters.
(2)
The sequence of parameters setting as following:
Connecting the loadcell , the indicator enters into working mode which is shown in
the Graph 2-3.
Insert the setting jumper into 15-pin socket at the back of indicator. (There is a 15-pin
plug in the packing carton with its 14-pin shorte connected with 15-pin. ).
Setup communication parameters as following:
Step Operation Display
Explanation
1
Press[CALB]
Plug in calibration jumper
2
Press[Enter]
[E **]
Don’t change this data and enter next step.
3
Press[Enter]
[dc **]
Don’t change this data and enter next step.
4
Press[Enter]
[Pon **]
Don’t change this data and enter next step.
5
Press[Enter]
[F
******]
Don’t change this data and enter next step.
6
Press[Enter]
Press[Enter]
[H *****]
[L *****]
[td **.**]
Don’t change this data and enter next step.
7
Press[1]
Press[Enter]
[A d r **]
[A d r01 ]
Communication address (01~26)
Example: 1
8
Press[1]
Press[Enter]
[bt *]
[bt 1]
Baud rate of serial communication (0~4)
which represent baud rate of
600,1200,2400,4800,9600
9
Press[0]
Press[Enter]
[tF *]
[tF 0]
Serial communication mode:
0-
Continous transmitting mode,
unreceiving
1-
command responding mode
10
Weighing
mode
End of communication parameters setting
( Please note the explanation. Don’t change other parameters setting carelessly )
4.7 Date, Time Set-up
（
1
）
Under weighing status of the indicator, press [ Date ] key, and date sign lamp is
lighted. Indicator display original data at this time. If it is correct, then press
