Epson UB-E02, Technical Reference Manual

Page: 45 / 86

Rev. A Utilities 3-19
UB-E02 Technical Reference Guide
Password
The EPSON TMNet WinConfig can set a password to protect the UB-E02 settings. The screen
shown below appears when you click
OK or Return to Default.
❏
When you set the password the first time or you change the password, click the Change
button. No password is registered until you set one.
❏
When you click the
Change
button, the screen shown below appears. Input the password
(up to 20 single-byte alphanumeric characters) and then click OK . Capital and lower-case
characters are distinguished.
CAUTION:
The password is used for both the EPSON TMNet WinConfig and the EPSON TMNet Web
Config. When you use either utility, be sure to control the password.
The new password is effective after clicking the OK button to send the configuration
data. Right after the setting, using the Administrator password, input the current
password.
If you forget your password, you need to return all settings to the default settings. Refer
to the Initializing UB-E02 and Status Sheet Printing section in Chapter 2.