74
4
Remove the slip paper. After approximately one second, the status of the Cut sheet
LED changes as follows.
Notes on Use
Be sure to align slip papers with the right-side guide and form stopper when setting them. If the paper is
inserted at an angle, the slip detection (TOF: Top of Form, BOF: Bottom of Form sensors) cannot operate
properly and the paper cannot be clamped. Also, let go of the paper quickly once it is clamped by the printer.
Remove the printed slip paper and then set the next slip paper for printing. If you do not remove the printed
slip paper first, the printer cannot recognize that the sheet has been removed and does not move onto the
next operation.
The slip section of this printer uses ink jet printing, and cannot be used with pressure-sensitive forms.
The slip section of this printer is only for use with single-sheet paper. Do not insert multi-part forms, as they
may cause paper jams.
Next print data
LED status
If there is no next data
OFF
If there is next data
Flashing
Confirm that the Cut sheet LED is not repeating a double-flashing pattern when inserting the next
slip paper.
If the next slip paper is inserted while the Cut sheet LED is repeating the double-flashing pattern,
Removal for Slip ejection is not cancelled even if the printed paper is removed. For this reason,
printing will not start even if the next print data arrives. When this occurs, remove the inserted
paper, and confirm that the Cut sheet LED is turned off or flashing continuously before inserting the
paper again.
Top of Form sensor
Bottom of Form sensor
