Epson Stylus Pro 7400, Service Manual

Page: 25 / 428

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Product Description Basic Specifications 25
BORDERLESS PRINTING SETTING PROCEDURES BORDERLESS PRINTING GUARANTEE CONDITIONS
†
Borderless printing guarantee conditions
„
Environmental:
Temperature: 59 to 77ºF (15 to 25 ºC), Humidity: 40 to 60 % RH
„
Media type *
4
: Photo type media (roll paper),
POP • poster type media (roll paper)
*
1 ,
*
2 ,
*
3
„
Media size * 4
•
Photo type media: 10”, 300mm, 13”, 16”, 17”, 24”, 36”, 44”
•
POP • poster type media: A1, B1, B2
NOTE "*1": For details on borderless printing guaranteed media, refer to “1.2.4.4
Allowable EPSON and Other Media” (p.18) .
"*2": There are no borderless printing guarantees for cut sheet paper.
"*3": Borderless printing is not guaranteed if a number of outer layers of the
roll surface have stretched due to moisture absorption.
"*4": Borderless ptinting on media and sizes other than those listed above are
guaranteed the same way as the Stylus Pro 7600/9600 do. However, if
media that has been stretched by humidity and other environmental
conditions is used, it is possible that borders on the right and left hand
sides may occur.
†
Bleeding print width for printing off both left and right edges
The bleeding print width for the left and right edges can be selected among the
following settings using the printer driver.
„
Left (opposite home side) = 1.5mm/ Right (home side) = 1.5mm
„
Left (opposite home side) = 3.0mm/ Right (home side) = 3.0mm (Default)
„
Left (opposite home side) = 5.0mm/ Right (home side) = 3.0mm * 1, * 2
NOTE "*1": If humid environmental conditions have caused the media to stretch,
“Left (opposite home side) = 5.0mm/ Right (home side) = 3.0mm”
selection is recommended to prevent left and right edge margins
occurring.
"*2": The “Left (opposite home side) = 5.0mm/ Right (home side) = 3.0mm”
setting shifts the center position of the image 1 mm away from that of
the print data.
Table 1-14. Borderless Printing Setting
Borderless
print mode
Right/left borderless
4 sides borderless
Single Cut
4 sides borderless
Double Cut
Printer
operation
Driver
setting Borderless print • Borderless print
• Single Cut • Borderless print
• Double Cut
Remarks Defined as default • As the top edge of the
first page is cut by
interrupting the printing
operation, off-registration
may occur causing
irregular color on the
printed image depending
on the print job.
• As this mode cuts the
paper on the boundary of
pages, slight amount of
image of the previous or
the next page may be left
on the top or bottom edge
of the printout due to
cutter position deviation.
• As the top edge of the
first page is cut by
interrupting the printing
operation, off-registration
may occur causing
irregular color on the
printed image depending
on the print job.
• The cutting position is set
to a line 1 mm inside from
the actual top and bottom
edges allowing for cutter
position deviation. So the
length of the printout
becomes about 2mm
smaller than the specified
size.