Epson STYLUS COLOR 480, Service Manual

Page: 103 / 149

EPSON Stylus COLOR 480 Revision B
Adjustment Overview 103
5.1.4 Adjustment Program Initial Setting menu
You have to input the following four items before entering the adjustment main menu.
o
Model name (Stylus COLOR 480)
o
Interface setting (LPT1, LPT2, LPT3)
o
Market (World, ESP, EIO)
o
Program type (Individual service adjustment program or Sequential repair service
program)
Follow the procedure below to input the initial settings.
1. When you run this program, the following menu appears. Select the Stylus COLOR
480 in the screen below.
Figure 5-3. Model Name Selection
NOTE: This printer stores model name in the PROM. Therefore, even you select
the model name in the screen above, model name will not stored in the
EEPROM. Selecting model name in the screen above determines
respective special command for each model.
2. Select the Parallel Interface port number which you connect the printer to your PC as
above Figure 5-3.
3. Select the suitable destination in the market menu. “World” is the standard destination
setting except the ESP and EIO. The waste drain ink pad life for ESP & EIO product is
different from World standard. So, you have to select the suitable destination in order
to set the suitable waste drain ink pad life. This setting is used when the waste drain ink
pad counter is reset or the main board is replaced with new one in the adjustment
program.
Figure 5-4. Destination Setting
4. Select the Program type which you will run in the menu.
Figure 5-5. Program type selection.