EPSON Stylus Color 400 Service Manual
Rev. A
3-16
3.2.4.5 Removing the PF Motor Assembly
1. Remove the housing.(Refer to 3.2.1)
2. Remove the absorber tray assembly ;A. (Refer to 3.2.4.2)
3. Remove the following gears located on the left side of the printer mechanism. Refer to the figure
below.
Gear 67.2 (Remove the ring with tweezers or (-) driver. After the ring is removed,
if you try to remove the gear 67.2 holding its edge, the gear may be broken. So, try
to remove it holding the whole gear, slightly pulling it toward you.)
Combination gear 8.8,21.6
Combination gear 8,14.4
Gear 36
4. Remove 3 hexagon nuts and take the PF motor assembly out.
When disassembling the PF motor assembly, pull the motor assembly out of the frame a little bit
and remove it, sliding it into the bigger hole on the frame. (Refer to the figure next page)
Be careful for the direction of wires from the PF motor assembly.
Do not damage or leave any scars on the ditches of the gears during the disassembly and
assembly.
WORK POINT
C-Ring
PR Motor Assembly
Hexagon Nut
Compression Spring 0.9
Gear 67.2
Combination Spring 8.8,21.6
Gear 36
Combination Gear8,14.4
Gear 34
Figure 3-13. Removing the PF Motor Assembly
Summary of Contents for Stylus Color 400
