3 FUNCTION OPTION GENERATOR FOG6008
10
EPSON
S5U1C60N08D MANUAL
(DEVELOPMENT SOFTWARE TOOL FOR S1C60N08)
*** OPTION NO.3 ***
--- MULTIPLE KEY ENTRY RESET ---
COMBINATION
1. NOT USE
2. USE K00,K01
3. USE K00,K01,K02
4. USE K00,K01,K02,K03
PLEASE SELECT NO.(1) ? 2
TIME AUTHORIZE
1. USE
2. NOT USE
PLEASE SELECT NO.(1) ? 1
COMBINATION 2. USE K00,K01 SELECTED
AUTHORIZE 1. USE SELECTED
3.3 Option Specifications and Selection Message
Screen that can be selected as function options set on the S1C60N08 are shown below, and their specifica-
tions are also described.
Select an oscillator type for the OSC3 oscillation
circuit.
To minimize external components, CR oscillation
circuit would be suitable; to obtain a stable
oscillation frequency, ceramic oscillation circuit
would be suitable. When CR oscillation circuit is
selected, only a resistor is needed as a external
component since a capacitor is built-in.
On the other hand, when ceramic oscillation circuit
is selected, a ceramic oscillator, a gate capacitor
and a drain capacitor are needed as external
components. When ceramic oscillation circuit is
selected, the oscillation frequency is fixed at 500
kHz; when CR oscillation circuit is selected, it may
be adjusted to a certain extent depending on the
external resistor.
1 Device type
*** OPTION NO.1 ***
--- DEVICE TYPE ---
DEVICE TYPE
1. E0C6008
2. E0C60L08
3. E0C60A08
PLEASE SELECT NO.(1) ? 3
DEVICE TYPE 3. E0C60A08 SELECTED
Select the chip specification.
E0C6008 (S1C60N08), E0C60L08 (S1C60L08)
and E0C60A08 (S1C60A08) denote 3 V power
source voltage specification, LOW POWER
specification for 1.5 V power source voltage, and
TWIN CLOCK specification, respectively.
When E0C6008 or E0C60L08 is selected, OSC3
oscillation circuit is fixed at CR oscillation.
However, it can not be used.
2 OSC3 system clock
*** OPTION NO.2 ***
--- OSC3 SYSTEM CLOCK ---
OSC3 SYSTEM CLOCK
1. CR
2. CERAMIC
PLEASE SELECT NO.(1) ? 1
OSC3 SYSTEM CLOCK 1. CR SELECTED
* The above selection is only possible with 60A08.
3 Multiple key entry reset
The reset function when K00 through K03 are
entered and the time authorize circuit are
configured.
When "NOT USE" is set for the combination, the
reset function is not activated even if K00 through
K03 are entered. When "USE K00, K01" is set, the
system is reset immediately the K00 and K01
inputs go high at the same time. Similarly, the
system is reset as soon as the K00 through K02
inputs or the K00 through K03 inputs go high.
When "USE" is set for the time authorize circuit, a
simultaneous high input time is authorized. The
system is reset when a signal is input for more than
1 to 3 sec.
Select the OSC1 clock frequency (crystal) for the
evaluation board.
Either 32.768 kHz or 38.4 kHz can be selected.
Crystal selection for evaluation board
--- CLOCK TYPE ---
CLOCK TYPE
1. 32KHZ
2. 38KHZ
PLEASE SELECT NO.(1) ? 1
CLOCK TYPE 1. 32KHZ SELECTED
Summary of Contents for S5U1C60N08D
Page 4: ......
