Epson S1C62 Family, Reference Manual

Page: 80 / 219

FUNCTION OPTION GENERATOR FOG62XX
V-6
EPSON
S1C62 FAMILY
DEVELOPMENT TOOL REFERENCE MANUAL
(5) PLEASE INPUT ANY COMMENT
When modifying a comment, enter all the comment lines anew, beginning with the first line; comment
data cannot be partially modified. Previously entered comment data can be used by pressing the
RETURN key "
". The input condition are the same as for new settings.
(6) PLEASE INPUT EDIT NO.?
Enter the number of the function option to be modified, then start setting the option contents.
When selection of one option is complete, the system prompts entry of another function option number.
Repeat selection until all options to be modified are selected.
If the "
" key is pressed without entering a number, the option of the subsequent number can be
selected.
Enter "E " to end option setting. Then, move to the confirmation procedure for HEX file generation
(See Section 4.5).
Example: • When modifying the settings of the function option of No. 9
PLEASE INPUT EDIT NO.? 9
• When ending setting
PLEASE INPUT EDIT NO.? E
4.4 Selecting Function Options
Option selection is done interactively. For new settings, set Options 1 to last sequentially; to modify
settings, the specified option number may be set directly.
*** OPTION NO.3 ***
--- MULTIPLE KEY ENTRY RESET ---
COMBINATION 1. Not Use
2. Use K00,K01
3. Use K00,K01,K02
4. Use K00,K01,K02,K03
PLEASE SELECT NO.(1) ? 2
COMBINATION 2. Use K00,K01 SELECTED
*** OPTION NO.4 ***
--- INTERRUPT NOISE REJECTOR ---
K00-K03 1. Use
2. Not Use
PLEASE SELECT NO.(1) ? B
*** OPTION NO.3 ***
--- MULTIPLE KEY ENTRY RESET ---
COMBINATION 1. Not Use
2. Use K00,K01
3. Use K00,K01,K02
4. Use K00,K01,K02,K03
PLEASE SELECT NO.(1) ?
The selections for each option correspond
one to one to the option list. While refer-
ring to the contents recorded in the option
list, enter the selection number.
In the message that prompts entry, the
value in parentheses ( ) indicates the
default value in case of new settings, or the
previously set value in case of setting
modification. This value is set when only
the RETURN key "
" is pressed.
In return, the confirmation is displayed.
When you wish to modify previously set
function options in the new setting
process, enter "B
" to return 1 step back to
the previous function option setting
operation.
When function option setting is completed,
move to the confirmation procedure for
HEX file generation (See Section 4.5).