Epson ProofPlus TM-H6000III, Technical Reference Manual

Page: 68 / 140

3-6 Setup Rev. E
3.1.5 Card insertion method (Option)
When you would like to scan a card with the TM-H6000III with Photo-ID, follow the following
procedure.
1. Transmit control command to TM-H6000III from your application for card insertion.
Note:
The control command depends on your control method. See Chapter 5 or Chapter 6 according to your
method for confirming the command.
3. The printer will detect the card and start drawing it in. When the printer starts drawing it in,
let go of the card immediately.
4. The printer scans the card while ejecting it.
5. When the ID light starts flashing again, remove the card by pulling it straight out; do not
pull it at an angle.
Note:
Appropriate image data quality might not be acquired in the following conditions:
• Excessive damage such as curvature, cracking, or folding of the card.
• Embossed cards.
• When the image scanner part is exposed to excessive light such as sunlight, a spotlight, or
fluorescent lamp.
• When the scanner glass has been damaged by foreign matter such as sand.
2. When the TM-H6000III receives the transmitted control
command, the ID LED blinks. Insert the card face up into the
card entrance as far as far it will go.
(See illustration on the right.)