MENU
a a
a a
abc
a b c
Configuring the printer
Configuring the printer
3-13
3-14
S
Paper Exit
(only for
printer with cutter
)
S
Emulation
It is possible to choose between
BATCH
(to leave the printer at the rear) and
The emulation determines the set of commands available for the printer (see
STACKER
(at the top) via the point
PATH
.
Appendix D to F
).
If
BATCH
is selected, the paper keeps its continuous form and leaves the
S
IBM PROPR.
printer at the rear. The cutter is not activated by default. If print jobs need to
S
IBM PROPR.AGM
be separated, the cutter must be activated.
S
EPSON LQ
If
STACKER
is selected the fanfold paper automatically leaves the printer as
Note:
The selected Emulation will also be stored in the actual macro. With a
cut sheets which are collected face down in the stacker at the top. The paper
change of the macro (e.g. key
,
,
or
is pressed) it is
is cut along the perforation as long as no other form length has been defined.
possible that the emulation will also be changed. Be careful: Do not
The form length can be determined in the menu or by the application. Printing
change the emulation within an application.
briefly stops when the paper arrives at the cut station. The paper gets cut and
is transported to the stacker. Afterwards, printing resumes.
S
Character Set
Note:
If, for some reason, it is not desired to print exactly on the perforation it is
corresponding national versions.
very important to
cut below the perforation
of the printed page. If the
Detailed tables of the character sets can be found in
Appendix B
.
paper is cut above the perforation the remaining paper can easily bend
and cause a paper jam. Do not cut through a label as the blad would get
dirty by the glue.
S
STACK.CAPACITY
(capacity at the top)
(only for the
printer with cutter
)
S
BATCH CAPACITY
(capacity of the option at
Cut Sheet Tray
at the
rear)
(only for the
printer with cutter
)
To control the capacity of the Stacker or the Cut Sheet Tray use these two
functions. Capacity can be defined in steps of 20 single sheets.
S
STACK.CAPACITY
in the range from 20 to 200 and
S
BATCH CAPACITY
from 20 to 600 sheets. (single sheet paper, see
chapter
6 Technical Data, paper specification
)
Change of Paper Exit
(only for the
printer with cutter
)
When switching from one paper exit to the other, paper in the printer moves
automatically to the cut station where it is cut at the perforation below the last
printed page.
S
PHILIPS GP
When selecting a character set it can be further specified by the
If a different macro is selected the default character set may change,
e.g.
- PHILIPS GP emulation has the character set NV-2.5 as default.
- IBM PROPR. emulation has the character set IBM SET 2 as default.
- EPSON emulation has the character set EPSON EXT.GCT as
default.
S
Line Mode
If LF = LF + CR is selected, the printer performs a carriage return (CR) for
every line feed (LF) received via the interface.
If CR = LF + CR is selected, the printer performs a line feed (LF) for every
carriage return (CR) received via the interface.
S
$$ Commands
This function causes $$ either to be printed as $$ or to activate ESC
commands within an application.
If this function is set to
YES
the characters are interpreted by the printer in
the following way:
S
$$
as
ESC [
S
$$/
as
ESC
.
