Getting Started
Getting Started
1-3
1-4
Note:
Mount the Cutter and the Top Cover (only for the
printer with cutter
) as
1.2
Installing the Personality Module
described in the enclosed Packing Note.
Do not connect to the mains until the mains voltage selection has been
called a Personality Module (PM).
checked and the PM is installed.
Repacking Information
Note:
- To avoid damage due to electrostatic discharge, do not touch the pins
Save all packing material and boxes for future transportation of the printer.
or components of the PM.
To ensure maximum protection when transporting the printer, please pay
- Never attempt to install or remove a PM while the printer is switched
attention to the following:
ON.
1. Push the output stacker into the top cover and remove the power cord.
1. Remove the PM (16) from its packing material.
2. Remove the ribbon cassette.
2. Insert the Personality Module (16) with the component side upwards until the
3. Pack the complete printer in its original packing box and ship it.
connector fully engages. Hand tighten the two lock screws (17).
Pay attention to the 'Packing Note'!
The printer functions only in combination with an installed interface module,
The illustration below shows the standard PM with a serial and parallel interface.
For detailed information about your PM, see Chapter 2.
