Epson PhotoPC 850Z, Service Manual, Page: 83 / 127

EPSON PhotoPC 850Z Revision A
Disassembly and Assembly Assembly Procedure 83
4.3.13 Assembly of Cabinet Front
4.3.13.1 Assembly of Lens Barrier
1. Apply grease to holes of the Cover Lens A (1) and Cover Lens B (2) (see
Chapter 6).
2. Install the Spring Cover Lens (3) on the Cover Lens A.
3. Install the Cover Lens A and B on the Holder Barrier (4).
4. Hang the Spring Cover Lens on the pin of the Cover Lens.
Figure 4-23. Assembly of Lens Barrier
5. Fix the TB2 Board (2) on the Holder Gear Cam (1) with one screw (1.7x5.0)
(3).
(Tightening torque: 1.3 ~ 1.7kgf-cm)
C H E C K
P O I N T
Make sure that the spring is not pinched by the Cover
Lens A.
After assembling the Cover Lens A and B, make sure that
the Cover Lens A closes normally when you open it
slightly and then release it.
Hang the tip of Spring
on the pin.
Lubrication Lubrication