Epson PhotoPC 800, Service Manual, Page: 91 / 110

EPSON PhotoPC 800 Revision A
Maintenance Preventive Maintenance 91
6.1 Preventive Maintenance
PhotoPC-800 does not require specific maintenance such as lubrication or
cleaning on a regular basis. However, it is necessary to perform cleaning
according to its necessity if any dirt or fingerprints are found attached on the
parts during the repair service. The table below lists check items and cleaning
points when the repair service is completed.
6.1.1 Check Points
Refer to the table6-1 and perform proper service referring to Chapter 4
Disassembly and Assembly, if you find any stain or defective parts. Dust or
finger prints can be removed by touching it several times with Scotch tape.
Table 6-1. Items to check
No. Check Points Check
1
Is in and out of lens viewfinder free from the finger
prints or dirt? Also, Aren’t any power supply cable
seen out of viewfinder?
†
OK
†
NG
2
Does the dial(rotary) switch move smoothly and
feeling to click ?
†
OK
†
NG
3
Do you see any dirt or dust in and out sides of flash
window?
†
OK
†
NG
4
Are the glass surface of the LCD panel on the SY1
board and in and out sides of protection board of the
rear cabinet free from the finger prints or dirt?
†
OK
†
NG
5 Is the lens surface free from the fingerprints or dust?
†
OK
†
NG
6
Is the glass surface of LCD monitor free from the
finger prints or dust?
†
OK
†
NG
7 Does the battery cover close or open normally?
†
OK
†
NG
8
Can the compact flash memory card be inserted
correctly?
†
OK
†
NG
9
Is the rubber cover, which covers various connectors
and serial connector installed at the rear cabinet
correctly?
†
OK
†
NG
10 Does the each panel switch work normally?
†
OK
†
NG
11 Is the exterior clean?
†
OK
†
NG